Barbell Bench Press
You lie flat on the bench with the bar out of the rack and stacked over your shoulder joint. From there you lower it under control to your lower chest and press it back up along the same path into straight arms. Your shoulder blades stay squeezed together and on the bench throughout.
The barbell bench press is the version of the horizontal push where you move the most weight. Both hands are on one bar, which keeps them on a shared path, and you get to focus on pressing.
Your chest and triceps do the main work, with the front delt contributing noticeably less. Retracted shoulder blades give your ribcage a solid base — from there the bar tracks a clean path.
Grip width mainly shifts how much the triceps takes on: the narrower the grip, the more. For the chest itself, the work stays similar across a wide range of grip widths.
Taking the bar all the way to your chest builds more strength on the bench press than partial reps do.
Starting position
Set up the bench. The bar sits in the rack so you can lift it out with straight arms while lying down. Set the safety arms so the bar would land just below your ribcage as you lie there. Lie flat with your eyes roughly under the bar.
Park your shoulders. Pull your shoulder blades together and down, as if you were driving them into the bench. You hold that position for the whole rep — it gives your ribcage a solid base.
Your feet. Plant your feet flat on the floor, wider than your hips, and keep them there. Your glutes stay in contact with the bench. If the floor is a stretch, set each foot on a flat plate.
The grip. Grip just inside one and a half times shoulder width. The bar sits low in your hand, over the heel of your hand, with your thumbs wrapped around it.
The movement. Lift the bar out of the rack and stack it over your shoulder joint — that's where it sits at the start and end of every rep. From there, lower it on a slight forward angle until it touches your lower chest, then press it back up along the same path, over your shoulder. Keep your upper arms at roughly 45 degrees to your torso, halfway between tucked in and flared out, with your elbows sitting under the bar. With the grip width to match, your forearms will be close to vertical at the bottom.
The three cues
- Shoulder blades together and driven into the bench — and they stay there
- Feet planted, wider than your hips
- The bar comes down to your lower chest, low on the ribcage
- Elbows tucked to about 45 degrees — halfway between in and flared, sitting under the bar
- Brief contact at the bottom, then drive back up along the same path
Common faults
| Fault | How to fix it |
|---|---|
| Your shoulder blades come off the bench as you press | Set them down and back before the first rep. That position holds for the whole set — it's the base for the bar path. |
| The bar comes down on your throat or collarbone | The touch point is your lower chest. From there the path runs slightly up and back, over your shoulder joint. |
| Your elbows flare out to 90 degrees | Keep your upper arms at roughly 45 degrees, halfway between tucked and flared, so your elbows sit under the bar. With the grip width to match, your forearms will be close to vertical at the bottom. |
| Your feet wander or come up onto the bench | Both feet stay flat on the floor, wider than your hips. If the floor is a stretch, set each foot on a flat plate. |
| The bar bounces off your chest | Make brief contact at the bottom and press deliberately from there. That keeps the path under your control. |
| The top of the rep gets cut short | Lock out into straight arms and touch your chest at the bottom. The full range is the one that counts. |
| Safeties left off and the rack height unchecked | Set the safety arms so the bar would land just below your ribcage as you lie there — before the first set. That's what makes training on your own work cleanly. |
Variations
| Variation | When to use it |
|---|---|
| Dumbbell bench press | Work with dumbbells first. Move on once your shoulder blades stay squeezed for the whole set and the path runs clean. |
| Empty bar | Groove the path with the empty bar, dial in your grip width, and set the rack height and safety arms. |
| Barbell bench press | Full reps: touch your chest, press into straight arms, shoulder blades parked. |
| More weight | Add load step by step, as long as the path stays the same across every rep. |
Reps and load
Andreas uses the barbell bench press as the main horizontal push, early in the session while you're fresh. The dumbbell version stays for anyone whose shoulder needs attention — it lets each person set the range to their own shoulder.
Training on your own, set the safety arms before the first set.
Keep grip width the same across sets: it's part of the lift, just like the bar path.
Which muscles do the work
| Muscle | Role | What it does here |
|---|---|---|
| Pectoralis major M. pectoralis major | Prime mover | Brings the upper arm forward and across toward the midline — the driver of the press |
| Triceps M. triceps brachii | Prime mover | Extends the elbow and carries the top half of the press |
| Anterior deltoid M. deltoideus pars clavicularis | Synergist | Assists shoulder flexion, contributing noticeably less than the chest and triceps |
| Serratus anterior M. serratus anterior | Stabiliser | Holds the shoulder blade flat against the ribs as you press |
| Trapezius and rhomboids M. trapezius, Mm. rhomboidei | Stabiliser | Keep the shoulder blades squeezed together and on the bench for the whole rep |
| Rotator cuff M. subscapularis, M. infraspinatus, M. teres minor, M. supraspinatus | Stabiliser | Keeps the head of the humerus in the socket while the load sits over the shoulder |
| Pectoralis minor M. pectoralis minor | Stabiliser | Pulls the shoulder blade forward and down — stays deliberately quiet here so the parked position holds |
| Trunk and legs M. erector spinae, M. gluteus maximus, M. quadriceps femoris | Stabiliser | Keep your trunk and pelvis quiet while your feet stay planted on the floor |
Chest and triceps do the main work together — the front delt sits clearly behind them here, contrary to what the usual ranking suggests. The rest of the table holds: serratus, trapezius and rhomboids park the shoulder blade, the rotator cuff secures the joint, and your trunk and legs give the whole thing a quiet base through your feet on the floor.
Seeing it done right is not the same as doing it right
Video, cues and variations take you a long way. What they cannot give you is an outside eye at the moment the movement isn't quite there yet. That is what training with me is for — in the studio or in a workshop.
See the workshopsNew exercise pages are added all the time — the newsletter keeps you posted.
Sources
Stastny P, Gołaś A, Blazek D, et al. (2017). A systematic review of surface electromyography analyses of the bench press movement task. PLoS One 12(2):e0171632. DOI: 10.1371/journal.pone.0171632 — 14 cross-sectional surface-EMG studies of the bench press. The basis for the muscle table — with one correction stated here explicitly: the triceps and pectoralis major read similarly high, and both clearly above the anterior deltoid. The common ranking 'chest, front delt, triceps' misrepresents what was measured. Only men aged 21 to 35 with at least six months of resistance training were included, 11 to 22 per study, and the authors restrict their conclusion to that group. For working adults aged 40 to 60, the anatomical assignment holds; the size of the values remains open. (Evidence type: Systematische Übersicht)
Saeterbakken AH, Stien N, Pedersen H, et al. (2021). The Effect of Grip Width on Muscle Strength and Electromyographic Activity in Bench Press among Novice- and Resistance-Trained Men. Int J Environ Res Public Health 18(12):6444. DOI: 10.3390/ijerph18126444 — 28 men, 13 of them novices — the only grip-width study with an untrained subgroup. Narrow (shoulder width), medium and 81 cm grips were compared. Result: the pectoralis major works equally hard across all three widths; the triceps reads lower with the wide grip, the biceps higher, and the narrow grip costs 6 to 8 per cent of the load. Larsen 2021 (Front Sports Act Living 2:637066) finds the same picture at 1RM. That leaves the rule of thumb 'wide for chest, narrow for triceps' refuted in its first half by measurement. Participant ages are not reported; all cohorts sit around 20 to 30 years. (Evidence type: EMG)
Noteboom L, Belli I, Hoozemans MJM, Seth A, Veeger HEJ, Van Der Helm FCT. (2024). Effects of bench press technique variations on musculoskeletal shoulder loads and potential injury risk. Front Physiol 15:1393235. DOI: 10.3389/fphys.2024.1393235 — 10 experienced lifters around 27 years old, motion capture driving a shoulder model. Wider grips raised total force at the glenohumeral and AC joints; grips under one and a half times shoulder width lowered AC compression. On elbow angle: a small 45-degree angle raised superior shear at the glenohumeral joint, larger angles lowered it, and both effects appeared only in very short windows — overall the angle mattered less than grip width and scapular position. Two limits belong with it: the model ran at 16 kilograms, not training load, and the work measures forces, not injuries. The authors state themselves that no biomechanical evidence for lowering injury risk is currently available. (Evidence type: Bewegungsanalyse mit Modellrechnung)
Martínez-Cava A, Hernández-Belmonte A, Courel-Ibáñez J, et al. (2022). Bench Press at Full Range of Motion Produces Greater Neuromuscular Adaptations Than Partial Executions After Prolonged Resistance Training. J Strength Cond Res 36(1):10–15. DOI: 10.1519/JSC.0000000000003391 — 50 men, 10 weeks, four groups: full range, two thirds, one third and control, all at the same relative load. Full range came out best across every bench press variation tested, and the advantage shrank as the range shortened. Drawn precisely: what was measured is strength and bar speed, not muscle thickness — which is why this page carries full range as a strength argument rather than a growth one. A review across all exercises (Wolf 2023) finds only a very small average advantage for full range. Participants ranged from recreational to well trained, all under 40. (Evidence type: Randomisierte Trainingsstudie)
Saeterbakken AH, van den Tillaar R, Fimland MS. (2011). A comparison of muscle activity and 1-RM strength of three chest-press exercises with different stability requirements. J Sports Sci 29(5):533–538. DOI: 10.1080/02640414.2010.543916 — 12 resistance-trained men around 23 years old, comparing Smith machine, barbell and dumbbells. With dumbbells the load was 17 per cent lower than with the barbell — that is the supported difference. For the pectoralis major and anterior deltoid, however, there was no difference between the variations; the biceps rose with the stability demand and the triceps read lower with dumbbells. The common claim that dumbbells activate the chest more is therefore refuted. Young trained men; no measurement of its own exists for working adults aged 40 to 60. (Evidence type: EMG)
A note on context: EMG studies show which muscles an exercise recruits — that is a good reason to pick it, but it does not replace adjusting things to the person in front of you. See a doctor for persistent or severe pain.